1
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
SPECIFICATIONS / ACCESSORIES / OPTIONS / SUPPLIES
1 - 3
HDD......................................... 60GB
Account Codes ........................ 10,000 codes
Department Codes .................. 1,000 codes
Warming-up time ..................... Approx. 20 sec. (temperature: 20°C)
Power requirements ................ AC 110 V / 13.2 A, 115 V or 127 V / 12 A
220-240 V or 240 V / 8 A (50/60 Hz)
* The acceptable value of each voltage is ±10%.
Power consumption................. 1.5 kW or less (115 V series, 200 V series)
* The electric power is supplied to the RADF, (ADU), Finisher, Job Separator, Offset Tray, PFP and
LCF through the equipment.
Total counter............................ Electronical counter
Dimensions of the equipment...................... See the figure below (W 575 x D 586 x H 756 (mm))
* The height includes the surface of the original glass.
* When the tilt angle of the control panel is 7 to 84 degrees.
Fig. 1-1
Weight ..................................... Approximately 57 kg (125.66 lb.): e-STUDIO205L/255/305 (include the
developer material and drum)
Approximately 60 kg (132.28 lb.): e-STUDIO355/455 (include the
developer material and drum)
586
756
575
7-84°
To Next Page
Loading...
