3
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
ADJUSTMENT
3 - 61
3.12 Adjustment of the RADF
3.12.1 Adjustment of RADF position
Perform this adjustment when the RADF is not installed in the correct position.
Note:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the RADF.
[A] Checking
(1) Open the RADF and install 2 positioning pins
(the positioning pins are installed to the back
side of the hinge which is on the left side of
the RADF).
Fig. 3-56
(2) Remove the platen sheet.
Fig. 3-57
(3) Close the RADF and check if the positioning
pins fit the holes on the RADF.
Fig. 3-58
To Next Page
Loading...
