5
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
PREVENTIVE MAINTENANCE (PM)
5 - 47
5.10 Maintenance Part List
The parts used for the maintenance of this equipment are as follows.
No. Item Purpose
Parts list
<P-I>
1 Door switch jig Used to adjust high-voltage
transformer.
101-1
2 Brush Cleaning inside of the equipment 101-2
3 Doctor sleeve jig Measuring the gap between the
development sleeve and the doctor
blade
101-3
4 Developer material nozzle Pouring the developer material
(attached to the developer bottle)
101-4
5 Wire holder jig Fixing the wire at the assembly of the
carriage wire
101-5
6 Belt tension jig Adjusting the belt tension at the
installation of the scan motor
101-6
7 High-voltage transformer jig Used to adjust high-voltage
transformer.
101-7
8 Downloading jig (DLM board) Updating the scanner/options ROM 102-1
9 Download JIG-2 (6 Flash ROMs) Updating the system/engine ROM 102-2
10 ROM writer adapter (For 1881) Writing the data of PWA-DWNLD-350-
JIG2
102-4
11 ROM writer adapter (For 1931) Writing the data of PWA-DWNLD-350-
JIG2
102-5
To Next Page
Loading...
