e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSIS MODES
2 - 2
State transition diagram of self-diagnosis modes
Fig. 2-1
*1. Turn OFF the power after using the self-diagnosis modes, and leave the equipment to the user.
2.1.1 Control panel check mode (01)
Operation procedure
The mode can be canceled by [POWER] OFF/ON when the LED is lit and the LCD is blinking.
Button Check
• Press the buttons with LED to turn OFF the LED.
• Press the buttons without LED to display the message on the control panel.
• Press the button on touch panel to display the screen on the control panel at power-ON.
Press [execution] on the touch panel and then the [CLEAR] button on the control panel. The screen
then returns to the Button Check menu.
2.1.2 Test mode (03)
Refer to the following.
P.2-4 "2.2 Input Check (Test Mode 03)"
P.2-12 "2.3 Output Check (Test Mode 03)"
2.1.3 Test print mode (04)
Refer to the following.
P.2-16 "2.4 Test Print Mode (Test Mode 04)"
2.1.4 Adjustment mode (05)
Refer to the following.
P.2-29 "2.6 Adjustment Mode (05)"
Warming up
Control panel
check mode
Test mode
Test print
mode
Adjustment
mode
Setting
mode
List print
mode
PM support
mode
Firmware
update mode
[POWER]
ON
Normal
Ready
[POWER]
OFF
To user
*1
[0][1] [0][3] [0][4] [0][5] [0][8] [9][START] [6][START]
[8][9]/[4][9]
EPU
replacement
mode
[7][START]
[0][1]
[POWER]
LED lit/
LCD blinking
[START]
[START]
(Button check)
[POWER] OFF/ON
(Exit)
To Next Page
Loading...
