Toshiba e-STUDIO355 - Adjustment of the Scanner Section

e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 48
3.9 Adjustment of the Scanner Section
3.9.1 Carriages
[A] Installing carriage wires
When replacing the carriage wires, refer illustrations below:
[Front side]
Fig. 3-30
[Rear side]
Fig. 3-31
Adjustment of the carriage wire tension is not necessary since a certain tension is applied to the
carriage wires by the tension springs.
Note:
Make sure the tension applied to the wire is normal.
Carriage-2
Carriage wire
Bracket for carriage-1
Wire pulley
Idler pulley
Tension spring
Hook
Carriage-2
Carriage wire
Bracket for carriage-1
Hook
Wire pull
e
Tension spring
Idler pulley