e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 90
3.15.2 Adjusting the stapling position
Perform this adjustment after replacing the Finisher control board or when the stapling position must be
changed for some reason.
(1) Turn OFF the power of the equipment.
(2) Remove 1 screw and take off the board access cover.
(3) Set the SW1 on the Finisher control board as shown in the figures below.
Fig. 3-102
Fig. 3-103
(4) Turn ON the power of the equipment while [0] button and [8] button are pressed simultaneously.
The alignment plate moves to the rear or front side stapling position and stops. (It stops at the
position of -20 steps from the center value of the adjustment range.)
SW1
Access cover
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
When adjusting the trailing
edge side for A4 size paper
When adjusting the trailing
edge side for LT size paper
When adjusting the leading
edge side for A4 size paper
When adjusting the leading
edge side for LT size paper
To Next Page
Loading...
