e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
8 - 50
8.4 Confirmation of the updated data
After the updating is completed, check each data version in Setting Mode (08) to confirm that the data
were overwritten properly.
The installed ROM versions and the registered optional Electronic License Keys can be confirmed in
the list print mode following the procedure below.
(1) Turn the power ON using the main power switch while pressing the digital key [9] and the
[START] button simultaneously.
* When the equipment is already in the other setting mode, press the [ON/OFF] button on the
control panel instead of using the main switch.
(2) Key in “1” three times, and then press the [START] button.
(3) “VERSION LIST” is printed out.
* It is recommended to keep this list for future reinstallation such as the replacement of the SYS
board.
(4) Keep pressing the [ON/OFF] button until you hear a sound to shut down the equipment.
Firmware Code Remarks
Updating HDD/UI data 08-944 HDD Version
08-924 Version of UI data language 1 in HDD
Updating System ROM 08-900 System firmware ROM version
08-921 System firmware ROM internal program version
Updating OS 08-920 FROM basic section software version
Updating Engine ROM 08-903 Engine ROM version
Updating Scanner ROM 08-905 Scanner ROM version
Updating RADF ROM 08-907 RADF ROM version
Updating Finisher ROM 08-908 Finisher ROM version
08-911 Hole punch unit ROM version (MJ-6101 only)
08-9945 Converter board ROM version
Updating FAX ROM 08-915 FAX ROM version
To Next Page
Loading...
