e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
6 - 6
EA10 Finisher jam
(Finisher unit)
Paper transport delay jam: The paper which has
passed the bridge unit does not reach the inlet
sensor.
Paper transport delay jam: The paper which has
passed the bridge unit does not reach the inlet
sensor. [MJ-1024/1031/1101]
P. 6 - 52
EA20 Paper transport stop jam: The paper does not pass
through the inlet sensor. [MJ-1025/MJ-1031]
Paper transport stop jam: The paper has passed
through the inlet sensor but does not reach or pass
the feed path sensor or processing tray sensor.
[MJ-1024]
Paper transport delay jam:
The paper which has passed through the inlet
sensor does not reach the transport sensor. [MJ-
1101]
P. 6 - 52
EA21 Paper size error jam: Paper does not reach the
sensor because the paper is shorter than spec.
P. 6 - 53
EA22 Paper transport jam (Finisher paper punching edge
detection sensor):]
P. 6 - 53
EA23 Paper transport jam (exit sensor) P. 6-54
EA24 Paper transport jam (between entrance and exit
sensors)
P. 6 - 54
EA25 Paper transport jam (after paper stack exit) P. 6-54
EA26 Paper transport jam (stop command request) P. 6-54
EA27 Paper transport jam (paper not inserted) P. 6-54
EA28 Paper transport jam (assisting arm operation delay) P. 6-54
EA29 Paper transport jam (stack transport delay) P. 6-54
EA30 Power-ON jam: Paper exists at the inlet sensor
when power is turned ON.
P. 6 - 54
EA31 Transport path paper remaining jam P. 6-54
EA32 Exit paper remaining jam P. 6-55
EA40 Door open jam: The Finisher is released from the
equipment or any of the staple door and top cover
is opened during printing. [MJ-1025]
Door open jam: Any of the upper cover and front
cover of the Finisher or any of the upper door and
front door of the Hole Punch Unit is opened during
printing. [MJ-1024]
Joint open jam: The joint is released during printing
or in the standby status. [MJ-1031]
P. 6 - 55
EA50 Stapling jam: Stapling is not performed properly. P. 6-56
EA60 Early arrival jam: The inlet sensor detects the paper
earlier than a specified timing.
P. 6 - 57
EA70 Stack delivery jam: It cannot deliver the stack of
paper on the intermediary process tray to the stack
tray. [MJ-1025]
Stack slider home position error: The stack slider is
not at the home position. [MJ-1031]
P. 6 - 58
Error code Classification Contents Troubleshooting
To Next Page
Loading...
