6
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
ERROR CODE AND TROUBLESHOOTING
6 - 27
[E030] Paper remaining inside the equipment at power-ON
Relation between the jamming area and the corresponding sensors and covers
(If a jam is occurring in the ADU, LCF, PFP, JSP or OCT check the board in each unit.)
[E061] Incorrect paper size setting for upper drawer
[E062] Incorrect paper size setting for lower drawer
[E063] Incorrect paper size setting for PFP upper drawer
[E064] Incorrect paper size setting for PFP lower drawer
[E065] Incorrect paper size setting for bypass tray
If any paper remains in the equipment or drawer, remove it. Match the paper size of the drawer
setting and the one in the drawer.
* Paper size detection is performed at the first sheet of paper when the drawer is opened or
closed, or when the power of the equipment is turned ON.
Open the cover of the unit/area whose picture is blinking on the control panel. Is there any
paper on the transport path? (Refer to the following table.)
YES Remove the paper.
NO
Is the sensor in the jamming area working? (Perform the input check in the test mode: refer
to the following table.)
l
l
l
l
l
l
l
l
NO 1. Check if the connector of the sensor is disconnected.
2. Check if any of the connectors on the LGC board is disconnected.
3. Check if the connector pins are disconnected and the harnesses are
open circuited.
4. Check if the conductor pattern on the LGC board is short circuited or
open circuited.
5. Replace the sensor.
6. Replace the LGC board.
YES
Replace the LGC board.
Jamming area Cover Sensor Test mode / Input check
Registration area Automatic duplexing
unit
Registration sensor 03-[FAX]ON/[9]/[A]
1st transport sensor 03-[FAX]OFF/[6]/[A]
Exit area Automatic duplexing
unit
Exit sensor 03-[FAX]ON/[9]/[B]
ADU ADU ADU entrance sensor 03-[FAX]OFF/[1]/[D]
ADU exit sensor 03-[FAX]OFF/[1]/E]
Feeding area
(Main unit)
Feed cover 2nd transport sensor 03-[FAX]OFF/[7]/[A]
LCF LCF side cover LCF feed sensor 03-[FAX]OFF/[4]/[C]
PFP PFP side cover PFP upper drawer feed sensor 03-[FAX]OFF/[2]/[B]
PFP lower drawer feed sensor 03-[FAX]OFF/[3]/[B]
Bridge unit Bridge unit Bridge unit transport sensor-1 03-[FAX]ON/[4]/[G]
03-[FAX]ON/[3]/[G]
Bridge unit transport sensor-2 03-[FAX]ON/[4]/[F]
03-[FAX]ON/[3]/[G]
JSP JSP cover JSP feed sensor 03-[FAX]ON/[3]/G]
OCT OCT cover OCT feed sensor 03-[FAX]ON/[3]/[G]
To Next Page
Loading...
