e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
6 - 52
[ 3 ] Paper jam in finisher section
[EA10] Paper transport delay jam
MJ-1025
1. Check if there is any paper remaining in the Finisher or on the transport path of the equipment.
Remove if there is.
2. Check if the connector pins are disconnected or the harnesses are open circuited between the
inlet sensor and the connector on the finisher controller PC board. Correct if there is any
abnormality.
3. ICheck if the inlet sensor is working normally. (Correct if the actuator does not return normally or
if it is deformed or removed.)
4. Replace the sensor.
5. Replace the finisher controller PC board.
MJ-1024
1. Check if there is any paper in the finisher or on the transport path of the equipment and remove it
if there is.
2. Check if the connector J708 on the finisher controller PC board is disconnected from the inlet
sensor (P133) or the harnesses are open circuited. Correct if any.
3. Is the inlet sensor working properly? (Check the movement of the actuator.)
4. Replace the inlet sensor.
5. Replace the finisher controller PC board.
MJ-1031
1. Check if there is any paper in the finisher or on the transport path of the equipment and remove it
if there is.
2. Check if the connector J104 on the finisher controller PC board is disconnected from the inlet
sensor (SR2) or the harnesses are open circuited. Correct if any.
3. Is the inlet sensor working properly? (Check the movement of the actuator.)
4. Replace the inlet sensor.
5. Replace the finisher controller PC board.
MJ-1101
1. Check if there is any paper in the finisher or on the transport path of the equipment and remove it
if there is.
2. Is there a disconnection of the connector, incorrect installation or breakage of the entrance
sensor (S1)?
3. Is the gap between the flapper and entrance roller shaft other than 0.60?0.20mm when the gate
solenoid (SOL2) is pulled?.
4. Is the harness between the entrance motor (M1) and the finisher control PC board (CN7)
disconnected or open circuited?
5. Is the harness between the gate solenoid (SOL2) and the finisher control PC board (CN22)
disconnected or open circuited?
6. Replace the finisher controller PC board.
[EA20] Paper transport stop jam
MJ-1025
Is there any paper remaining on the transport path in the finisher?
YES Remove the paper.
NO
Is the connector CN16 (inlet sensor) on the finisher controller PC board disconnected?
Is the harness connecting the finisher controller PC board and inlet sensor open-circuited?
YES Connect the connector securely. Replace the harness.
NO
To Next Page
Loading...
