Toshiba e-STUDIO355 - Page 466

e-STUDIO205L/255/305/355/455 © 2009 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
6 - 62
[ 5 ] Other paper jam
[EAD0] Print end command time-out jam
[EAE0] Receiving time time-out jam
[EB30] Ready time-out jam
1. Check if there is any paper in the equipment. Remove it if there is.
2. Check if the connector on the equipment is disconnected from the finisher or the harnesses are
open circuited. Correct if any.
3. Replace the IPC board.
4. Replace the LGC board.
5. Replace the finisher controller PC board.
[ED10] Skew adjustment motor (M1) home position detection abnormality
MJ-1101 (when MJ-6101 is installed)
1. Check if there is any paper in the finisher or the on the transport path of the equipment. Remove
it if there is.
2. Rotate skew adjustment motor and fix its mechanism if it does not rotate smoothly.
3. Check if the connectors on the hole punch controller PC board (HP board) are disconnected from
the skew HP sensor (S2) and the skew adjustment motor, or the harnesses are open circuited.
Correct if any.
4. Replace the skew adjustment motor.
5. Replace the hole punch control PC board.
[ED11] Sideways adjustment motor (M2) home position detection error
MJ-1101 (when MJ-6101 is installed)
1. Check if there is any paper on the transport path and remove it if there is.
2. Rotate sideways adjustment motor and fix its mechanism if it does not rotate smoothly.
3. Check if the connectors on the hole punch controller PC board (HP board) are disconnected from
the sideways deviation HP sensor (S3)and the sideways adjustment motor, or the harnesses are
open circuited. Correct if any.
4. Replace the sideways adjustment motor.
5. Replace the hole punch control PC board.
Is the main motor rotating normally?

NO
1. Replace the SYS board.
2. Replace the LGC board.
Is the finisher working?

YES  Replace the finisher controller PC board.
NO
1. Check if the voltage (24V) is being supplied to the finisher.
2. Check the connection of the LGC board and IPC board.
3. Check if the harness connecting the IPC board and finisher I/F connector of the
equipment side is open circuited.
4. Check if the harness connecting the I/F connector of the finisher side and finisher
controller PC board is open circuited.
5. Replace the finisher controller PC board.