Toshiba e-STUDIO355 - Page 471

6
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO205L/255/305/355/455
ERROR CODE AND TROUBLESHOOTING
6 - 67
[C180] LCF tray-up motor is abnormal
[C1A0] LCF end fence motor is abnormal
Does the tray move? (Perform the output check in the test mode: 03-271)
l
l
l
l
l
l
l
l
l

NO  1. Check if the connector of the LCF tray-up motor is disconnected.
2. Check if any of the connectors CN1 and CN5 on the LCF board is
disconnected.
3. Check if the connector CN318 on the LGC board is disconnected.
4. Check if the connector pins are disconnected and the harnesses are
open circuited.
5. Check if the conductor patterns on the LCF board and LGC board are
short circuited or open circuited.
6. Replace the LCF board.
7. Replace the LGC board.
YES
Are the LCF tray bottom sensor and LCF tray-up sensor working?
(Perform the input check in the test mode: 03-[FAX]OFF/[5]/[A], /[5]/[B])
l
l
l
l
l
l
l
l
l
l
l
l

NO  1. Check if the connectors of the sensors are disconnected.
2. Check if any of the connectors CN1, CN2 and CN6 on the LCF board
is disconnected.
3. Check if the connector CN318 on the LGC board is disconnected.
4. Check if the slit reaches the sensors.
5. Check if the connector pins are disconnected and the harnesses are
open circuited.
6. Check if the conductor patterns on the LCF board and LGC board are
short circuited or open circuited.
7. Replace the LCF board.
8. Replace the LGC board.
YES
1. Check if the conductor pattern on the LGC board is short circuited or open circuited.
2. Replace the LGC board.
Is the LCF end fence motor working? (Perform the output check in the test mode: 03-207)
l
l
l
l
l
l
l
l

NO  1. Check if the connector of the LCF end fence motor is disconnected.
2. Check if any of the connectors CN1 and CN5 on the LCF board is
disconnected.
3. Check if the connector CN318 on the LGC board is disconnected.
4. Check if the connector pins are disconnected and the harnesses are
open circuited.
5. Check if the conductor patterns on the LCF board and LGC board are
short circuited or open circuited.
6. Replace the LCF board.
7. Replace the LGC board.
YES