2.SCANNING (BASIC OPERATION)
Saving Data in the Shared Folder 23
SCANNING (BASIC OPERATION)
- When you select [NetwareIPX]:
Enter the name of the NetWare file server or the Tree/Context (when NDS is available).
- When you select [NetwareIP]:
Enter the IP address of the NetWare file server.
[Network Path]
- When you select [FTP] or [FTPS]:
Enter the path to a folder in the FTP server where you want to store the scanned data. For example, to
transfer the scanned data to “ftp://10.10.70.101/user01/scan/,” enter “user01\scan” in this box.
- When you select [SMB]:
Enter the network path to the folder where you want to store the scanned data.
- When you select [NetwareIPX] or [NetwareIP]:
Enter the path to a folder in the NetWare file server where you want to store the scanned data. For example,
to transfer the scanned data to the “sys\scan” folder in the NetWare file server, enter “\sys\scan” in this box.
[Login User Name]
- When you select [FTP] or [FTPS]:
Enter the log-in user name for the FTP server if required.
- When you select [SMB]:
Enter the user name to access the network folder if required.
- When you select [NetwareIPX] or [NetwareIP]:
Enter the log-in user name for the NetWare file server if required.
[Password]
- When you select [FTP] or [FTPS]:
Enter the log-in password for the FTP server if required.
- When you select [SMB]:
Enter the password for accessing the network folder if required.
- When you select [NetwareIPX] or [NetwareIP]:
Enter the log-in password for the NetWare file server if required.
[Command Port] (FTP and FTPS only)
Enter the port number to be used for command execution. By default, a hyphen “-” is entered in this box, and
the port number set by the administrator is used. Change the entry in this box only when you want to use
another port number.
When you select [SMB] for a protocol, enter the network path, login user name and password then press , so
that you can select the folder.
To Next Page
Loading...
Need help?
General
