Toshiba HX7+ ASD - Page 176

HX7+ ASD Installation and Operation Manual 167
Pattern Run #10 Run-Time Setting
Program Pattern Run Preset Speeds 10
This parameter sets the run-time value for the #10 Preset Speed mode when
used as part of a Pattern Run.
Direct Access Number — F594
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — No
Minimum — 1
Maximum — 8000
Units — Seconds
Pattern Run #11 Run-Time Setting
Program Pattern Run Preset Speeds 11
This parameter sets the run-time value for the #11 Preset Speed mode when
used as part of a Pattern Run.
Direct Access Number — F595
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — No
Minimum — 1
Maximum — 8000
Units — Seconds
Pattern Run #12 Run-Time Setting
Program Pattern Run Preset Speeds 12
This parameter sets the run-time value for the #12 Preset Speed mode when
used as part of a Pattern Run.
Direct Access Number — F596
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — No
Minimum — 1
Maximum — 8000
Units — Seconds
Pattern Run #13 Run-Time Setting
Program Pattern Run Preset Speeds 13
This parameter sets the run-time value for the #13 Preset Speed mode when
used as part of a Pattern Run.
Direct Access Number — F597
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — No
Minimum — 1
Maximum — 8000
Units — Seconds
Pattern Run #14 Run-Time Setting
Program Pattern Run Preset Speeds 14
This parameter sets the run-time value for the #14 Preset Speed mode when
used as part of a Pattern Run.
Direct Access Number — F598
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — No
Minimum — 1
Maximum — 8000
Units — Seconds
Pattern Run #15 Run-Time Setting
Program Pattern Run Preset Speeds 15
This parameter sets the run-time value for the #15 Preset Speed mode when
used as part of a Pattern Run.
Direct Access Number — F599
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — No
Minimum — 1
Maximum — 8000
Units — Seconds
F594 F599