Toshiba HX7+ ASD - Page 175

166 HX7+ ASD Installation and Operation Manual
Pattern Run #4 Run-Time Setting
Program Pattern Run Preset Speeds 4
This parameter sets the run-time value for the #4 Preset Speed mode when
used as part of a Pattern Run.
Direct Access Number — F588
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — No
Minimum — 1
Maximum — 8000
Units — Seconds
Pattern Run #5 Run-Time Setting
Program Pattern Run Preset Speeds 5
This parameter sets the run-time value for the #5 Preset Speed mode when
used as part of a Pattern Run.
Direct Access Number — F589
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — No
Minimum — 1
Maximum — 8000
Units — Seconds
Pattern Run #6 Run-Time Setting
Program Pattern Run Preset Speeds 6
This parameter sets the run-time value for the #6 Preset Speed mode when
used as part of a Pattern Run.
Direct Access Number — F590
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — No
Minimum — 1
Maximum — 8000
Units — Seconds
Pattern Run #7 Run-Time Setting
Program Pattern Run Preset Speeds 7
This parameter sets the run-time value for the #7 Preset Speed mode when
used as part of a Pattern Run.
Direct Access Number — F591
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — No
Minimum — 1
Maximum — 8000
Units — Seconds
Pattern Run #8 Run-Time Setting
Program Pattern Run Preset Speeds 8
This parameter sets the run-time value for the #8 Preset Speed mode when
used as part of a Pattern Run.
Direct Access Number — F592
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — No
Minimum — 1
Maximum — 8000
Units — Seconds
Pattern Run #9 Run-Time Setting
Program Pattern Run Preset Speeds 9
This parameter sets the run-time value for the #9 Preset Speed mode when
used as part of a Pattern Run.
Direct Access Number — F593
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — No
Minimum — 1
Maximum — 8000
Units — Seconds
F588 F593