Toshiba HX7+ ASD - Page 174

HX7+ ASD Installation and Operation Manual 165
Pattern #12 Characteristics
Program Pattern Run Preset Speeds 12
Same as #1 Pattern Characteristics (see F570).
Direct Access Number — F581
Parameter Type — Selection List
Factory Default — Time From Start
Changeable During Run — No
Pattern #13 Characteristics
Program Pattern Run Preset Speeds 13
Same as #1 Pattern Characteristics (see F570).
Direct Access Number — F582
Parameter Type — Selection List
Factory Default — Time From Start
Changeable During Run — No
Pattern #14 Characteristics
Program Pattern Run Preset Speeds 14
Same as #1 Pattern Characteristics (see F570).
Direct Access Number — F583
Parameter Type — Selection List
Factory Default — Time From Start
Changeable During Run — No
Pattern #15 Characteristics
Program Pattern Run Preset Speeds 15
Same as #1 Pattern Characteristics (see F570).
Direct Access Number — F584
Parameter Type — Selection List
Factory Default — Time From Start
Changeable During Run — No
Pattern Run #1 Run-Time Setting
Program Pattern Run Preset Speeds 1
This parameter sets the run-time value for the #1 Preset Speed mode when
used as part of a Pattern Run.
Direct Access Number — F585
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — No
Minimum — 1
Maximum — 8000
Units — Seconds
Pattern Run #2 Continuation Mode Run-Time Setting
Program Pattern Run Preset Speeds 2
This parameter sets the run-time value for the #2 Preset Speed mode when
used as part of a Pattern Run.
Direct Access Number — F586
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — No
Minimum — 1
Maximum — 8000
Units — Seconds
Pattern Run #3 Run-Time Setting
Program Pattern Run Preset Speeds 3
This parameter sets the run-time value for the #3 Preset Speed mode when
used as part of a Pattern Run.
Direct Access Number — F587
Parameter Type — Numerical
Factory Default — 5
Changeable During Run — No
Minimum — 1
Maximum — 8000
Units — Seconds
F581 F587