HX7+ ASD Installation and Operation Manual 87
Input Terminal 12 Assignment
Program Terminal Selection Input Terminals
This parameter selects the functionality of the #12 input terminal.
Note: The #12 input terminal may be used without the ASD-Multicom
option board.
Without the ASD-Multicom option board the #12 terminal
assignment information will be stored in volatile memory. The
terminal assignment information will be lost if the system is
powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable terminal #12 to 1 of the 68 possible
functions that are listed in
Table 14 on pg. 189.
Direct Access Number — F122
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Input Terminal 13 Assignment
Program Terminal Selection Input Terminals
This parameter selects the functionality of the #13 input terminal.
Note: The #13 input terminal may be used without the ASD-Multicom
option board.
Without the ASD-Multicom option board the #13 terminal
assignment information will be stored in volatile memory. The
terminal assignment information will be lost if the system is
powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable terminal #13 to 1 of the 68 possible
functions that are listed in
Table 14 on pg. 189.
Direct Access Number — F123
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
Input Terminal 14 Assignment
Program Terminal Selection Input Terminals
This parameter selects the functionality of the #14 input terminal.
Note: The #14 input terminal may be used without the ASD-Multicom
option board.
Without the ASD-Multicom option board the #14 terminal
assignment information will be stored in volatile memory. The
terminal assignment information will be lost if the system is
powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable terminal #14 to 1 of the 68 possible
functions that are listed in
Table 14 on pg. 189.
Direct Access Number — F124
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
F122 F124
To Next Page
Loading...
