GENERAL DESCRIPTION
Page 17
Use Listed compression connectors
suitable for the cable being used.
Use the
hardware provided with
the controller to attach cable
connectors to bus pads. After
installation, torque hardware to 45
ft.
After installation, check to see that at
least three inches clearance is
maintained between live parts of
opposite polarity and between live
parts and ground.
Fig. 17 Shielded Cable Termination
Bottom
Entry
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
To Next Page
Loading...
