RECEIVING AND HANDLING
Page 7
RECEIVING AND UNPACKING
Upon receipt of the equipment, do the
following:
Make an immediate inspection for any
damage which might have occurred
during shipment (Fig. 1). If damage is
found, it should be noted with the
carrier prior to accepting the shipment,
if possible.
Carefully unpack the equipment
sufficiently to check for concealed
damage and to determine that the
shipment is complete and correct.
Keep the equipment upright. If the
controller is not upright upon receipt,
notify the carrier of possible damage.
Upright the unit as soon as possible.
Do not lay the equipment
on its side or upside
down.
File a claim with the carrier for any
damaged or missing item and
immediately notify the nearest Toshiba
Representative.
Do not install or energize
equipment that has been
damaged.
HANDLING AND MOVING
Medium voltage motor controllers should be
handled with care, to avoid damage to
components and to the frame or its finish
(Fig. 2).
The capability of the moving equipment to
handle the weight of the controller shipping
section should be confirmed.
The equipment should remain secured to the
shipping skid to prevent distortion of the frame
during moving and to minimize tipping.
Extreme care should be exercised during any
Fig. 1 Inspect The Controller
Fig. 2 Moving The Controller
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
To Next Page
Loading...
Need help?
General
