4 Replacement Procedures Error! Style not defined. Error! Style not defined.
Qosmio X300 Maintenance Manual 4-44
Installing the MDC Module and System Board
Install the MDC Module and System Board according to the following procedures and Figure
4-24.
1. Seat the system board in the correct place on the computer’s base.
2. Secure one M2.5x6 screw on the lower hinge cover.
3. Secure the board to the computer’s base with three M2.5x4 screws.
4. Connect six cables with the system board.
5. Seat the MDC Module in the correct place and secure them with two M2.5x4 screws.
To Next Page
Loading...
Need help?
General