Base plate
Drain nipple
Water-proof rubber caps
(supplied with the outdoor unit)
10-4-3. Draining the Water
• Holes are provided on the base plate of the
outdoor unit to ensure that the defrost water
produced during heating operations is drained off
efficiently.
If a centralized drain is required when installing the
unit on a balcony or wall, follow the steps below to
drain off the water.
1. Proceed with water-proofing by installing the
water-proof rubber caps in the 2 elongated holes
on the base plate of the outdoor unit. [How to
install the waterproof rubber caps]
1) Place four fingers into each cap, and insert
the caps into the water drain holes by pushing
them into place from the underside of the base
plate.
2) Press down on the outer circumferences of
the caps to ensure that they have been
inserted tightly.
(Water leaks may result if the caps have not
been inserted properly, if their outer
circumferences lift up or the caps catch on or
wedge against something.)
Fig. 10-4-3
2. Install the drain nipple and a commercially
av
ailable dr
ain
hose
(with
16 mm inside
diam
eter), and drain off the water.
(For the position where the drain nipple is
installed, refer to the installation diagram of the
indoor and outdoor units.)
• Check that the outdoor unit is horizontal, and
route the drain hose at a downward sloped
angle while ensuring that it is connected tautly.
Do not use ordinary garden hose, but one can
flatten and prevent water from draining.
Fig. 10-4-4
Commercially available
drain hose
Base plate
Drain nipple
To Next Page
Loading...
