I-TOSHIBA-
r
7
AUTOMATIC DIALING (continued)
TELEPHONE NUMBER STORAGE (cont.)
*Repeat this procedure to replace the stored telephone
numbers with new ones. Entering an automatic dialing
code that has already been used will replace the current
telephone number with any new one entered.
““It may be necessary to insert a pause after the trunk
access code to allow for dial tone delay. If so, depress
the
m
(or
m
)
key after entering the PBX
access code.
*
AND # TONE DIALING
When the
*
or
#
tones must be output (for com-
puter input service or other use), the Automatic Dialing
feature must be disabled to permit manual dialing of
the
n
and
1
keys. (Applicable only if
w
and
m
keys are not programmed.)
TO OUTPUT
*
AND
#
TONES
1) Lift the handset.
2) Depress any available
m
line key.
3) Dial any desired directory number.
4) To disable the Automatic Dialing feature, thereby
permitting the
*
and
#
tones to be output man-
ually, press the
4
key and then the
i
key.
NOTE:
Only manual dialing will be possible; the special
*
and
# tones as well as digits 0
‘L
9 will be output as
dialed. The Automatic Dialing feature will be restored
when the EKT is hung up or placed on hold.
To Next Page
Loading...
