Toshiba Strata VIe - Call Transfer with Camp-On

TOSHIBA,
CALL HOLD and TRANSFER (cont.)
CALL TRANSFER WITH CAMP-ON
This feature allows you to transfer an outside call to
a station that is either idle or busy.
TO TRANSFER A CALL
1
1) While connected to an outside call, depress the
m key.
l The CO LED changes to conference flash.
l The INT LED will flash at the l-use flash rate.
l Intercom dial tone is heard.
2) Dial the station number to which the call is to be
transferred.
3A) If the called station is idle:
l You will hear a single ring tone.
4A) Announce the call.
5) Hang up.
l INT LED goes off.
l CO LED changes to the l-hold flash rate.
l The CO line rings the called station.
l CO LED illuminates steadily when the called
station connects with the transferred call.
l If the station fails to answer the call, you will
receive a recall ring after a predetermined time.
38) If the called station is busy:
l Busy tone is heard.
4B) Hang up.
l INT LED goes off.
l CO LED changes to l-hold flash rate.
l The CO line is camped-on to the called station.
l The called. station hears a warning tone.
l CO LED illuminates steadily when the station
connects with the transferred call.
NOTES:
1. The Busy Override feature may be used instead of
transfer camp-on.
2. The call will recall you and camp-on is cancelled if
the station does not pick it up within a predeter-
mined time. Inform the caller of the situation, and
repeat the procedure (if necessary).
(continued)