3.3 Setting of the hardware configuration 3 Tests and Diagnostics
TECRA M4 Maintenance Manual (960-521) [CONFIDENTIAL] 3-9
Setting of the HWSC
Setting of the UUID
Display of the DMI information (including UUID)
Setting of DVD region code (Yes/No)
After completion of the above settings, H/W configuration & DMI
information are appeared in order. Check the contents and press Enter.
Following message appears in the display. Press any key, then return to the
H/W initial information setting tool menu.
+------------------------------------------------+
+ It switches off the power on automatically. +
+------------------------------------------------+
Press any key to continue...
Subtest 03 DMI information save
NOTE: Before replacing the System board, be sure to execute this subtest and save the
DMI information to the floppy disk.
This is one of tools to copy the DMI information to a new PCB after
replacing.
This subtest saves all the DMI data in a floppy disk.
To Next Page
Loading...
