4 Replacement Procedures 4.9 Battery latch assembly / Selectable bay lock
4.9 Battery latch assembly / Selectable bay lock
4.9.1 Battery latch assembly
Removing the battery latch assembly
The following describes the procedure for removing the battery latch assembly. (See Figure
4-12.)
1. Remove the following screw securing the battery latch assembly.
• M2.5x4.0B FLAT BIND screw x1
2. Pull up to remove the battery latch assembly from the bottom cover assembly.
4-24 [CONFIDENTIAL] TECRA M4 Maintenance Manual (960-521)
Figure 4-12 Removing the battery latch assembly
Installing the battery latch assembly
The following describes the procedure for installing the battery latch assembly. (See Figure
4-12.)
1. Install the battery latch assembly to the bottom cover assembly.
2. Secure the battery latch assembly with the following screw.
• M2.5x4.0B FLAT BIND screw x1
Battery latch assembly M2.5x4.0B FLAT BIND
To Next Page
Loading...
