4 Replacement Procedures 4.11 Bluetooth module
4.11 Bluetooth module
Removing the Bluetooth module
To remove the Bluetooth module, follow the steps below. (See Figure 4-16.)
CAUTION: Do not try to remove the Bluetooth module with the computer turned on.
You can damage the computer or Bluetooth module. Do not touch the
connectors on the Bluetooth module on the computer. Debris on the
connectors may cause Bluetooth access problems.
1. Remove the following screw to remove the Bluetooth module.
• M2×3S S-FLAT HEAD screw ×1
2. Disconnect the Bluetooth cable (black) from the Bluetooth module using an antenna
coaxial cable disconnector.
3. Disconnect the flexible cable from the Bluetooth module.
M2×3S S-FLAT HEAD
Bluetooth module
Bluetooth cable
Flexible cable
Figure4-16 Removing the Bluetooth module
4-28 [CONFIDENTIAL] TECRA M4 Maintenance Manual (960-521)
To Next Page
Loading...
