Toshiba Tecra M4 - Hinge Switch Board

4.31 Hinge Switch Board 4 Replacement Procedures
4.31 Hinge Switch Board
Removing the hinge switch board
The following describes the procedure for removing the hinge switch board. (See Figure 4-
48.)
1. Remove the following screws and hinge switch board.
• M2.5x3.0B FLAT BIND screw x2
2. Remove the plate placed under the hinge switch board.
M2.5x3.0B
FLAT BIND
Hinge switch board
Figure 4-48 Removing the hinge switch board
Installing the hinge switch board
The following describes the procedure for installing hinge switch board. (See Figure 4-48.)
1. Install the plate fitting to the bosses on the hinge assembly.
2. Install the hinge switch board and secure it with the following screws.
• M2.5x3.0B FLAT BIND screw x2
TECRA M4 Maintenance Manual (960-521) [CONFIDENTIAL] 4-77