4.19 QI board / CN board 4 Replacement Procedures
4.19 QI board / CN board
4.19.1 QI board
Removing the QI board
The following describes the procedure for removing the QI board. (See Figure 4-29.)
1. Remove the following screws securing the QI board.
• M2.5x6.0B FLAT BIND screw x1
2. Pull up the QI board straight and remove the QI board from the cover assembly.
M2.5x6.0B FLAT BIND
QI board
Figure 4-29 Removing the QI board
Installing the QI board
The following describes the procedure for installing the QI board. (See Figure 4-29.)
1. Install the QI board to the cover assembly and secure it with the following screws.
• M2.5x6.0B FLAT BIND screw x1
TECRA M4 Maintenance Manual (960-521) [CONFIDENTIAL] 4-47
To Next Page
Loading...
