4 Replacement Procedures 4.8 Bottom cover assembly
4.8 Bottom cover assembly
Removing the bottom cover assembly
The following describes the procedure for removing the bottom cover assembly. (See Figure
4-10 and 4-11.)
1. Disconnect the touch pad cable from the connector CN3240 on the system board.
CN3240
Touch pad cable
Figure 4-10 Removing the touch pad cable
2. Close the display and turn the computer upside down.
3. Remove the following screws securing the bottom cover assembly.
• M2.0x6.0B FLAT BIND screw x20 (Described as (6) in figure)
• M2.0x4.0B FLAT BIND screw x2 (Described as (4) in figure)
4. Pull up to remove the bottom cover assembly from the computer.
4-22 [CONFIDENTIAL] TECRA M4 Maintenance Manual (960-521)
To Next Page
Loading...
