Toshiba Tecra M4 - Page 252

4.8 Bottom cover assembly 4 Replacement Procedures
(6)
(6)
(6)
(6)
(4)
(6)
(6)
(6)
(6)
(6)
(6)
(6)
(6)
(6)
(6)
(6)
(6)
(4)
(6)
(6)
(6)
(6)
Figure 4-11 Removing the bottom cover assembly
Installing the bottom cover assembly
The following describes the procedure for installing the bottom cover assembly. (See Figure
4-10 and 4-11.)
1. Install the bottom cover assembly to the computer.
Note: Install the bottom cover assembly from the i.LINK (IEEE1394) slot first.
2. Secure the bottom cover assembly with the following screws
• M2.0x6.0B FLAT BIND screw x20 (Described as (6) in figure)
• M2.0x4.0B S-THIN FLAT BIND screw x2 (Described as (4) in figure)
3. Turn over the computer and open the display.
4. Connect the touch pad cable to the connector CN3240 on the system board.
TECRA M4 Maintenance Manual (960-521) [CONFIDENTIAL] 4-23