Toshiba Tecra M4 - Selectable Bay Lock

4.9 Battery latch assembly / Selectable bay lock 4 Replacement Procedures
4.9.2 Selectable bay lock
Removing the Selectable bay lock
The following describes the procedure for removing the selectable bay lock. (See Figure 4-
13.)
1. Release the tabs (2 points) and detach the Selectable bay lock A.
2. Remove the Selectable bay lock B from the bottom cover assembly.
Selectable bay lock B
Selectable bay lock A
tab
Figure 4-13 Removing the selectable bay lock
Installing the selectable bay lock
The following describes the procedure for installing the selectable bay lock. (See Figure 4-
13.)
1. Install the Selectable bay lock B to the bottom cover assembly and Selectable bay
lock A form the back, then hook the tabs (2 points).
Caution: Selectable bay lock has different shapes of tabs for each side (2 points).
Therefore, be sure to fit their shapes for installation.
TECRA M4 Maintenance Manual (960-521) [CONFIDENTIAL] 4-25