4.25 Touch pad 4 Replacement Procedures
4.25 Touch pad
Removing the touch pad
The following describes the procedure for removing the touch pad. (See Figure 4-37.)
1. Peel the insulator.
2. Remove the following screws securing the touch pad.
• M2.0x4.0S S-THIN FLAT BIND screw x2
3. Remove the touch pad holder and touch pad from the cover assembly.
4. Peel off the glass tape and disconnect the touch pad cable from the touch pad.
M2.0x4.0B S-THIN FLAT BIND
Glass tape
Touch pad cable
Touch pad
Touch pad holder
Figure 4-37 Removing the touch pad
Installing the touch pad
The following describes the procedure for installing the touch pad (See Figure 4-37.).
1. Connect the touch pad cable to the touch pad and stick the glass tape.
2. Install the touch pad and touch pad holder to the cover assembly.
3. Secure the touch pad with the following screws and stick the insulator.
• M2.0x4.0B S-THIN FLAT BIND screw x2
TECRA M4 Maintenance Manual (960-521) [CONFIDENTIAL] 4-59
To Next Page
Loading...
