Toshiba Tecra M4 - Penholder;Rtc Battery

4.16 Penholder / RTC battery 4 Replacement Procedures
4.16 Penholder / RTC battery
4.16.1 Penholder
Removing the Penholder
The following describes the procedure for removing the Penholder. (See Figure 4-25.)
1. Disconnect the RTC batter cable from the connector CN9990 on the system board.
2. Remove the following screws securing the Penholder and remove the Penholder
from the cover assembly.
• M2.0x4.0B FLAT BIND screw x2
M2.0x4.0B FLAT BIND
Penholder
RTC battery cable
CN9990
Figure 4-25 Removing the Penholder
TECRA M4 Maintenance Manual (960-521) [CONFIDENTIAL] 4-41