4.22 Speaker 4 Replacement Procedures
4.22 Speaker
Removing the speaker
The following describes the procedure for removing the speaker. (See Figure 4-33.)
1. Turn up the guide insulator.
2. Pull out the speaker cable from the ferrite sheet of cover assembly.
3. Pull out the speaker from the slot of cover assembly.
Guide insulator
Speaker cable
Guide insulator
Speaker (R)
<White & Green cable>
Speaker (L)
<Red & Black cable>
Ferrite sheet
Figure 4-33 Removing the speaker
Installing the speaker
The following describes the procedure for installing the speaker. (See Figure 4-33.)
1. Install the speaker to the slot of cover assembly.
NOTE: When installing the speaker, confirm the right installation of right and left
speaker. (Right = White and Green cable, Left = Red and Black cable).
TECRA M4 Maintenance Manual (960-521) [CONFIDENTIAL] 4-53
To Next Page
Loading...
