Toshiba Tecra M4 - MDC;Modem Cable

4 Replacement Procedures 4.12 MDC / Modem cable
4.12 MDC / Modem cable
Removing the MDC / Modem cable
The following describes the procedure for removing the MDC / Modem cable. (See Figure 4-
17 and 4-18.)
1. Remove the following screws securing the MDC.
• M2.0x4.0Z BIND screw x2
2. Pull up the MDC straight and remove it from the connector CN3000 on the system
board.
3. Disconnect the Modem cable from the connector of MDC.
M2.0x4.0Z BIND
MDC
Modem cable
CN3000
Figure 4-17 Removing the MDC
4. Pull out the Modem cable from the guide of mini PCI cover.
4-30 [CONFIDENTIAL] TECRA M4 Maintenance Manual (960-521)