4.6 Selectable bay module 4 Replacement Procedures
TECRA M4 Maintenance Manual (960-521) [CONFIDENTIAL] 4-19
Installing the selectable bay module
The following describes the procedure for installing the selectable bay module. (See Figure
4-7 and 4-8.)
1. Install the plastic frame to the selectable bay module and secure them with following
screws.
• M2.0x3.0S S-THIN FLAT BIND screw x5
2. Install the OD board and plastic brace to the selectable bay module and secure them
with following screws.
• M2.0x8.0S BIND screw x2
3. Insert the selectable bay module into the selectable bay of the computer.
4. Turn the following screw (if you want to lock the selectable bay) from unlock
position to lock position.
• M2.5x4.0B FLAT BIND screw x1
To Next Page
Loading...
