Toshiba Tecra M4 - Page 273

4.17 LCD harness holder 4 Replacement Procedures
5. Remove the following screws securing and remove the LCD harness holder.
• M2.5x6.0B FLAT BIND screw x2
QI board cable
Insulator
CN9521
CN9530
M2.5x6.0B
FLAT BIND
CN board harness
(
to CN9520
)
USB harness
(
Connected to CN4621
)
USB harness
(
to CN4612
)
LCD harness
(
Connected to CN5501
)
CN board harness
(
Connected to CN9502
)
Figure 4-27 Removing the LCD harness holder
TECRA M4 Maintenance Manual (960-521) [CONFIDENTIAL] 4-43