4.29 Digitizer 4 Replacement Procedures
Removing the Digitizer
The following describes the procedure for removing the digitizer. (See Figure 4-44.)
1. Remove the following screws securing the digitizer.
• M2.0x3.0Z BIND screw x3
2. Slide out the digitizer toward the arrow pointing.
M2.0x3.0Z BIND
M2.0x3.0Z BIND
Digitizer
Figure 4-44 Removing the digitizer
Installing the digitizer
The following describes the procedure for installing the digitizer. (See Figure 4-44.)
1. Slide the digitizer into the back pocket of LCD.
Caution: When replacing the digitizer, fit the digitizer into the back of LCD toward the
arrow pointing.
2. Secure the digitizer with the following screws.
• M2.0x3.0Z BIND screw x3
TECRA M4 Maintenance Manual (960-521) [CONFIDENTIAL] 4-71
To Next Page
Loading...
