4.30 LCD harnesses & Wireless LAN/Bluetooth antennas 4 Replacement Procedures
6. Detach the cover assembly from the display cover.
LCD harness holder
M2.5x2.8B FLAT BIND
M2.5x6.0B FLAT BIND
M2.5x6.0S PSP TIGHT
Digitizer harness holder
Hinge rear cover
CPU stud
M2.5x6.0S PSP TIGHT
Glass tape
Hinge assembly
Figure 4-45 Removing the cover assembly
7. Remove the LCD harness ground plate from the display cover.
8. Remove the following screws and LCD harness hold plate from the display cover.
• M2.5x6.0B FLAT BIND screw x2
9. Remove the following screws securing the hinge assembly.
• M2.5x6.0B FLAT BIND screw x2
TECRA M4 Maintenance Manual (960-521) [CONFIDENTIAL] 4-73
To Next Page
Loading...
