2.15 Sound Troubleshooting 2 Troubleshooting Procedue
2.15 Sound Troubleshooting
This section describes how to determine if the computer’s sound functions are functioning
properly. Perform the steps below starting with Procedure 1 and continuing with the other
procedures as required.
Procedure 1: Diagnostic Test Program Execution Check
Procedure 2: Connecor Check
Procedure 3: Replacement Check
Procedure 1 Diagnostic Test Program Execution Check
Execute the Sound test in Sound Test program disk. Refer to Chapter 3, Tests and -
Diagnostics for more information on how to perform the test program.
If any error is detected by the test, go to Procedure 2.
Procedure 2 Connector Check-
The connection of sound system is shown in the following figure.
TECRA R10 Maintenance Manual (960-708) [CONFIDENTIAL] 2-53
To Next Page
Loading...
