4.19 Smart card slot 4 Replacement Procedure
4.19 Smart card slot
Removing the Smart card slot
To remove the Smart card slot, follow the steps below and refer to Figure 4-27.
1. Peel the INSU FPC SC on the TPAD PLT ASSY.
2. Disconnect the FPC of Smart card slot from the connector CN2170 on the system
board.
3. Lift the hook of Smart card slot and slide it to the left to remove.
Smart card slot
INSU FPC SC
T PAD PLT ASSY
CN2170
FPC of Smart card slot
Hook
Bluetooth module
harness
Figure 4-27 Removing the Smart card slot
TECRA R10 Maintenance Manual (960-708) [CONFIDENTIAL] 4-47
To Next Page
Loading...
