4.10 Keyboard 4 Replacement Procedures
4.10 Keyboard
Removing the Keyboard
To remove the keyboard, follow the steps below and refer to Figure 4-11 to 4-12.
CAUTION: As the keytop may fall out, when handling the keyboard always hold it by the
frame and do not touch the keytop.
1. Turn over the computer and open the display.
2. Insert your fingers into the slit and remove KB HOLDER while releasing the latches.
3. Remove the following screws securing the keyboard.
• M2.0×4B BIND screw ×2
4. Lift the top edge of the keyboard and turn the keyboard face down on the palm rest
portion of COVER ASSY.
KB HOLDER
Slit
M2.0x4B BIND
Keyboard
Figure 4-11 Removing the keyboard (1)
TECRA R10 Maintenance Manual (960-708) [CONFIDENTIAL] 4-23
To Next Page
Loading...
