Toshiba TECRA R10 - Optical Disk Drive (DVD-Super Multi Drive)

4.9 Optical disk drive (DVD-Super Multi drive) 4 Replacement Procedures
4.9 Optical disk drive (DVD-Super Multi drive)
Removing the Optical disk drive
To remove the Optical disk drive, follow the steps below and refer to Figure 4-9 to 4-10.
CAUTION: When the optical disk inside the optical disk drive can not be ejected because of
some failure, open the disc tray by inserting a slender object (about 15 mm)
such as a straightened paper clip into the eject hole near the eject button.
1. Remove the following screws securing the ODD ASSY.
• M2.5×6C FLAT HEAD screw ×2
2. Remove the ODD ASSY from the slot while pushing it in the direction as shown in the
figure below.
M2.5x6C FLAT HEAD
ODD ASSY
Figure 4-9 Removing the Optical disk drive (1)
NOTE: The circled number shows the order to drive the screws.
TECRA R10 Maintenance Manual (960-708) [CONFIDENTIAL] 4-21