4.2 Battery pack 4 Replacement Procedures
4.2 Battery pack
Removing the Battery pack
To remove the battery pack, follow the steps below and refer to Figure 4-1.
CAUTION: Take care not to short circuit the terminals when removing the battery pack.
Similarly, do not drop, knock, scratch, disassemble, twist, or bend the battery
pack.
1. Turn off the power of the computer.
2. Disconnect the AC adapter and other external devices from the computer.
3. Turn the computer face down.
4. Pull out the battery pack while releasing the battery latches as shown below.
Battery latch
Battery pack
Battery latch
Figure 4-1 Removing the battery pack
NOTE: Dispose of the used battery pack in accordance with the laws and ordinances of your
local authority.
TECRA R10 Maintenance Manual (960-708) [CONFIDENTIAL] 4-11
To Next Page
Loading...
