Toshiba TECRA R10 - Wireless LAN Card

4 Replacement Procedures 4.14 Wireless LAN card
4.14 Wireless LAN card
CAUTION: Do not touch the connectors on the Wireless LAN card. Debris on the connectors
may cause the wireless LAN card access problems.
Removing the Wireless LAN card
To remove the wireless LAN card, follow the steps below and refer to Figure 4-19.
1. Disconnect two Wireless LAN antenna cables from the wireless LAN card.
2. Remove the following screws securing wireless LAN card.
• M2.0×4B S-THIN HEAD screw ×2
3. Disconnect the Wireless LAN card from the connector CN2600 on the system board.
M2.0×4B S-THIN HEAD
Wireless LAN card
CN2600
Wireless LAN antenna cable
Figure 4-19 Removing the Wireless LAN card
4-34 [CONFIDENTIAL] TECRA R10 Maintenance Manual (960-708)