4.14 Wireless LAN card 4 Replacement Procedures
TECRA R10 Maintenance Manual (960-708) [CONFIDENTIAL] 4-35
Installing the Wireless LAN card
To install the Wireless LAN card, follow the steps below and refer to Figure 4-19.
1. Insert the Wireless LAN card to the connector CN2600 on the system board slantwise
and press it to connect firmly.
NOTE: Align the notch of the Wireless LAN card to the guide of the connector.
2. Secure the Wireless LAN card with the following screws.
• M2.0×4B S-THIN HEAD screw ×2
3. Connect two Wireless LAN antenna cables to the connectors on the wireless LAN card.
To Next Page
Loading...
