4 Replacement Procedure 4.29 LCD unit
4.29 LCD unit
Removing the LCD unit
To remove the LCD unit, follow the steps below and refer to Figure 4-46 to 4-50.
1. Peel off four LCD CUSHIONs and two MASK SEALs (black) from the LCD
MASK ASSY.
2. Peel off two MASK SEALs (silver) from the LCD COV CAP L and LCD COV
CAP R.
3. Remove the following screws securing the LCD COV CAP L and LCD COV CAP R.
• M2.0×8C OTHER screw ×2 (1 each)
4. Remove the following screws secure the LCD MASK ASSY.
• M2.5×4C FLAT HEAD screw ×6 (upper ×4, bottom 2 )
LCD MASK ASSY
M2.0x8C OTHER
M2.5x4C FLAT HEAD
LCD CUSHION
MASK SEAL
(silver)
MASK SEAL
(black)
LCD COV
CAP R
LCD COV
CAP L
MASK SEAL
(black)
Figure 4-46 Removing the LCD unit (1)
4-74 [CONFIDENTIAL] TECRA R10 Maintenance Manual (960-708)
To Next Page
Loading...
