4.20 SD board 4 Replacement Procedure
4.20 SD board
Removing the SD board
To remove the SD board, follow the steps below and refer to Figure 4-28.
1. Disconnect the SD BOARD FPC from the connector CN9530 on the system board.
2. Remove the following screws and SD board.
• M2.5×4C FLAT HEAD ×2
3. Disconnect SD BOARD FPC from the SD board.
SD BOARD FPC
SD board
M2.5x4C FLAT HEAD
CN9530
Figure 4-28 Removing the SD board
TECRA R10 Maintenance Manual (960-708) [CONFIDENTIAL] 4-49
To Next Page
Loading...
