4.18 Bluetooth module 4 Replacement Procedures
4.18 Bluetooth module
Removing the Bluetooth module
To remove the Bluetooth module, follow the steps below and refer to Figure 4-26.
1. Lift the hook of BT HOLDER up and slide it to remove.
2. Remove the Bluetooth module from the COVER ASSY.
3. Disconnect the BT HARNESS carefully from the connector of Bluetooth module.
Bluetooth module
BT HARNESS
Hook
Guide
Hole
BT HOLDER
Figure 4-26 Removing the Bluetooth module
TECRA R10 Maintenance Manual (960-708) [CONFIDENTIAL] 4-45
To Next Page
Loading...
