4.21 RGB HARNESS 4 Replacement Procedure
4.21 RGB HARNESS
Removing the RGB HARNESS
To remove the RGB HARNESS, follow the steps below and refer to Figure 4-29.
1. Remove the following screws to remove the RGB HARNESS from the slot.
• #4-40×5C UNIFIED screw ×2
2. Peel the INSU RGB HNS fixing the RGB HARNESS to the DC-FAN.
3. Disconnect the RGB HARNESS from the connector CN9510 on the system board.
RGB HARNESS
#4-40x5C UNIFIED
INSU RGB HNS
CN9510
Figure 4-29 Removing the RGB HARNESS
TECRA R10 Maintenance Manual (960-708) [CONFIDENTIAL] 4-51
To Next Page
Loading...
